Connect VPN Client on OpenSUSE

Once you install the vpnsetup.sh file using the following command:
sudo sh yoursetupfile.sh

your vpn software will be installed on the following location:
/opt/cisco

Now, navigate to:
/opt/cisco/anyconnect/bin

Open Terminal and Enter the following command:
 ./vpn connect vpn.nmsu.edu

Then you'll see the following screen:

Cisco AnyConnect Secure Mobility Client (version 3.1.04072) .

Copyright (c) 2004 - 2013 Cisco Systems, Inc.  All Rights Reserved.

  >> state: Disconnected

  >> state: Disconnected

  >> notice: Ready to connect.

  >> registered with local VPN subsystem.

  >> contacting host (vpn.nmsu.edu) for login information...

  >> notice: Contacting vpn.nmsu.edu.

  >> Connection Banner

  >> ©2014 NMSU Board of Regents

  >> Please enter your myNMSU username and password.

    0) NMSU

    1) NMSU-Full

    2) banner

Group: [NMSU]

Enter NMSU as a group.

Then, you'll be asked to enter username. Enter your nmsu username

Then, finally enter your nmsu password and you're done.

If you want to check if the connection is established, enter the following command again

 ./vpn connect vpn.nmsu.edu

and you'll see:

Cisco AnyConnect Secure Mobility Client (version 3.1.04072) .

Copyright (c) 2004 - 2013 Cisco Systems, Inc.  All Rights Reserved.

  >> state: Connected

  >> state: Connected

  >> notice: Connected to Not Available.

  >> registered with local VPN subsystem.

  >> contacting host (vpn.nmsu.edu) for login information...

  >> state: Connected

  >> state: Connected